| |
Technical
Specification |
| |
|
| |
Chipset |
| |
|
Intel 875/ICH5R |
| |
|
|
| |
Processor |
| |
|
Socket 478 |
| |
|
Intel® Pentium® 4 up to 3.06 GHz(FSB 333), 3.6GHz(FSB 800)
and
Celeron Processor up to 2.4GHz |
| |
|
800MHz system interface speed |
| |
|
4-phase Power Design for Optimal Performance |
| |
|
|
| |
Memory
|
| |
|
Dual Channel 128bit (See Dual Channel Guidelines) |
| |
|
4 x 184-pin DDR SDRAM DIMM |
| |
|
Maximum 4GB |
| |
|
PC3200/2700 DDR SDRAM |
| |
|
|
| |
Dual
Channel Guidelines |
| |
|
• Matched DIMM configuration in each channel
- Same Density (128MB, 256MB, 512MB, 1GB, etc.)
- Same DRAM technology(128M-bit, 256M-bit, or 512M-bit)
- Same DRAM bus width (x8 or x16)
- Both either single-sided or dual-sided |
| |
|
•
Matched in both Channel A and Channel B memory channels
- Populate symmetrical memory slots |
| |
|
•
Optimal platform performance with Dual Channel, DDR400, matched DIMMs
- Fully loaded configurations can be single or double sided DIMMs
- Lightly loaded configurations need to be double sided DIMMs |
| |
|
•
When not using DDR400, best performance obtained with
- Symmetrical DIMM population and matched double-sided DIMMs
- Lightly loaded configuration |
| |
|
|
| |
Dual
Channel Configuration Table DIMM Slot |
| |
|
| DIMM
Slot |
DDRA1 |
DDRA2 |
DDRB1 |
DDRB2 |
System
Density |
| Lightly
Loaded Config |
128MB
-- 1GB |
|
128MB
-- 1GB |
|
256MB
-- 2GB |
| Lightly
Loaded Config |
|
128MB
-- 1GB |
|
128MB
-- 1GB |
256MB
-- 2GB |
| Fully
Loaded Config |
128MB
-- 1GB |
128MB
-- 1GB |
128MB
-- 1GB |
128MB
-- 1GB |
512MB
-- 4GB |
|
| |
|
|
| |
EXPANTION
SLOT |
| |
|
5 x PCI |
| |
|
1 x AGP |
| |
|
1x CNR |
| |
|
1 x WLAN Module Slot |
| |
|
|
| |
I
/ O |
| |
|
•
1 x PS/2 mouse, 1 x PS/2 keyboard |
| |
|
• 8 x USB 2.0 Ports (4 x Rear USB 2.0 , 4 x Front USB 2.0 ) |
| |
|
• 1 x Parallel , 2 x Serial |
| |
|
• 1 x Lin-out/Lin-in/Mic |
| |
|
•
1 x RJ-45 LAN Jack |
| |
|
•
2 x FireWire IEEE1394a Ports (1 x Rear Port, 1 x Front Port) |
| |
|
•
2 x Serial ATA Connectors |
| |
|
•
1 x S/PDIF Header |
| |
|
• 1 x Chassis Open Header |
| |
|
• 1 x Wake On Lan Connector |
| |
|
•
1 x IrDA |
| |
|
•
1 x Front Audio Header |
| |
|
•
1 x Floppy |
| |
|
•
4 x IDE Hard Disk Devices |
| |
|
•
2 x Serial ATA Connectors |
| |
|
•
Support Ultra DMA 33/66/100 Bus Master Modes |
| |
|
|
| |
Integrated
Video |
| |
|
•
None |
| |
|
|
| |
Integrated
Audio |
| |
|
• C-Media CMI9739A 6-Channel AC¡¦97 CODEC |
| |
|
|
| |
WLAN |
| |
|
• RTL 8180 + BIOSTAR AirLink™ RF Module |
| |
|
|
| |
Gigabit
WLAN |
| |
|
• Intel 82547EI
- Supports Communicationn Streaming Architecture Interface(CSA)
- Direct Connect to the MCH of North Bridge (Intel 875P) |
| |
|
|
| |
SATA
RAID |
| |
|
• ICH5R/Intel RAID Technology
- Supports RAID 0(Striping)
- Data Transfer Rates up to 1.5GB/s
- Hard Drives Can Read and Write Data in Parallel to Enhance Performance |
| |
|
|
| |
IEEE1394a |
| |
|
• VIA VT6307
- Supports 2 Ports with Transfer up to 400mbps |
| |
|
|
| |
HARDWARE
MONITOR FUNCTION |
| |
|
•
CPU/System Fan Speed Controller
• CPU Temperature
• System Voltage
• Vcore,+3.3V,+5V,+12V, -5V, -12V,5VSB(Stand By), V Battery
|
| |
|
|
| |
WarpSpeeder |
| |
|
• OverClock
• OverVoltage
• Hardware Monitor |
| |
|
|
| |
Dimention
/ Form Factor |
| |
|
•
ATX form factor |
| |
|
•
Dimension: 24.4cm x 30.4cm ( W x L ) |
| |
|
|
